Product brief
The A series is a brand-new series of internal combustion balanced forklifts independently developed by Hangcha based on its existing products and adopting international advanced technologies. Through comprehensive upgrades in appearance design, safety, comfort, reliability and other aspects, the overall performance of the vehicle has been significantly improved compared with the original product. All engines comply with the third-stage emission requirements of GB 20891-2014.
The new Chai 4D32G31-001 engine is powerful.
● Bridge body steel plate welded structure, bearing reinforcement, thickened steering cylinder.
● Thickened frame (widened channel steel), thickened piston rods of lifting cylinder and tilting cylinder.
Product Introduction
01/ Introduction
The basic configuration is equipped with a new Chai 4D32G31 engine and an enhanced transmission.
● Reinforced derrick design (widened channel steel), thickened diameter of the inclined cylinder piston rod, and thickened diameter of the lifting cylinder to enhance the durability of the derrick.
The front wheels are equipped with 250-15-18PR tires to enhance tire durability.
The bridge body adopts a sheet metal welded structure, enlarges the bearings, thickens the diameter of the steering cylinder, and enhances the durability of the steering bridge.
Extend the wheelbase, increase the weight of the counterweight, and enhance the overload capacity.
Increase the displacement of the gear pump to enhance the lifting speed.
The exterior design is consistent with that of the A series internal combustion forklifts, with smooth lines and a strong sense of movement throughout the vehicle.
The engine hood is as integral as that of the A series internal combustion forklifts, which not only enhances the rigidity of the engine hood but also reduces noise.
Product configuration
Standard configuration
Protective steps for getting on and off vehicles
Cyclone air filter
Hydraulic oil dial
Traction device
Lift the oil circuit speed limit valve
Fully hydraulic-assisted steering
Second-level ultra-wide field of view mast
Standard fork
Standard seat
Oil-water separator
Raise and tilt the joystick
Steering wheel adjustment device
Large rubber pedal
Hold the handlebars
Roof covers and rain covers
Rearview mirror
Folder
Oil gauge
Two-piece multi-way valve
Electric oil pump
Preheating prompt
Engine oil pressure alarm
Neutral gear safety switch
Standard top guard frame
Transmission dipstick (Hydraulic transmission
High-performance tires
Standard rack
High-level air intake device
LED front small light and rear combination light
Engine Fault prompt
Hydraulic oil suction filter element
Inclined oil circuit self-locking valve
Cable-type parking brake
Electric horn
Tea cup holder
Front work light
Twist the buzzer
Three-stage fork frame
Comprehensive electrical box
Chronograph
Load safety valve
Engine hood gas spring
Charging prompt
Oil cooler (hydraulic transmission
Vehicle-mounted toolbox
Water temperature gauge
Transmission oil temperature alarm (hydraulic transmission)
Shut down
Optional configuration
Inclined cylinder guard sleeve
Double drive wheels
Taxi
High-level exhaust device
The user specifies the color
Cab warm air blower
Rear work light
LED work light
Double-layer heat insulation pad and hood leather cover
Taxi
Radiator grille
Solid tire
Colored tires (white/green)
Intermediate exhaust device
Exhaust fire prevention device
The seat was paused.
Exhaust purifier
The hood is locked
Odometer
Auxiliary hydraulic valve assembly
Speedometer
Fire extinguisher
Copper water tank
The rear armrest is equipped with horn buttons
Counterweight mesh cover
High and low top guard frames
Police light
Lock the fuel tank cap
Front and rear lamp protection frames
High-speed transmission
Main power switch
Fan protection device
Speed limit alarm
Double air filters
Seat with a seat belt
Product parameters
